How to perform smart analysis on triangular surfaces
So, I have a roof line that runs on an angle producing both triangular and quadrilateral panel surfaces. However, when I run the analysis it creates all quadrilateral panel surfaces to analyze but I need to keep the original form.
Please see the attached files.
Any suggestions would be great.
Thanks
- Attachments:
-
-
Surfacestoanalyze.png, 31 KB -
Analyzedsurfaces.png, 46 KB
-
Replies to This Discussion
-
Permalink Reply by Miguel Rus on
-
Hi Justin,
thank you for your question. From what I can see from the images, the surfaces you are inputting are trimmed. Avoid this, as you can get undesired results.
If you have any other questions do let us know.
© 2021 Created by Dr. Shrikant B. Sharma.
Powered by
