SMART Solutions Network

So, I have a roof line that runs on an angle producing both triangular and quadrilateral panel surfaces. However, when I run the analysis it creates all quadrilateral panel surfaces to analyze but I need to keep the original form.

Please see the attached files.

Any suggestions would be great.

Thanks

Views: 172

Attachments:

Reply to This

Replies to This Discussion

Hi Justin,

thank you for your question. From what I can see from the images, the surfaces you are inputting are trimmed. Avoid this, as you can get undesired results.

If you have any other questions do let us know.

 

RSS

© 2021   Created by Dr. Shrikant B. Sharma.   Powered by

Badges  |  Report an Issue  |  Terms of Service